--Getting the Most of Your Pocket PC Experience!

Frequently Asked Questions
Introduction
Step 1. Tools and Warnings
Step 2. Opening the Device
Step 3. Removing the ROM
Step 4. Some more Screws.
Step 5. Removing the Ribbon Cables
Step 6. More Ribbon Cables!
Step 7. Preparing to Overclock.
Step 8. Overclocking With The Pencil
Step 9. Tips On Reassembly.
Step 10. Testing Results!
Want Me To Do it For You?
Overclock Your EM-500-Guide By Fayle
Overclock Your E-125-Guide By Fayle
 
 

Step 6. More Ribbon Cables

You can now begin to seperate the unit. Caution though! There are still two more ribbon cable holding the main board to the screen module! Pull the board away from the other side of the outer case.

The ribbons circled above will need to be removed! Ribbon 1 is removed like the previous two ribbon cable. You will need to pull the plastic tabs that are holding it in place.
Once you have removed this ribbon cable, you can move to Ribbon 2. Ribbon 2 is not attached and held in place by a plastic clip like the other three ribbon cables. It is plugged into a socked similair to the ROM board.

You should be able to Seperate the E-115 into its major parts now- the main board, and the screen module. The Screen module should be able to be set aside, and you can flip the main board onto its other side in the back portion of the Plastic shell!

You should be able to move to the next step! Its time to Overclock!