--Getting the Most of Your Pocket PC Experience!

Frequently Asked Questions
Introduction
Step 1. Tools and Warnings
Step 2. Opening the Device
Step 3. Removing the ROM
Step 4. Some more Screws.
Step 5. Removing the Ribbon Cables
Step 6. More Ribbon Cables!
Step 7. Preparing to Overclock.
Step 8. Overclocking With The Pencil
Step 9. Tips On Reassembly.
Step 10. Testing Results!
Want Me To Do it For You?
Overclock Your EM-500-Guide By Fayle
Overclock Your E-125-Guide By Fayle
 
 

Step 9. Tips On Reassembly

Putting the unit back together pretty much requires doing the reverse of all the previous steps! So if you need help in putting it all back in place, review each step in reverse! A couple of things to remember when you are putting it back together. The pictures below show how the wires from the little board can block the infrared transmitter/receiver, be sure to tuck them away!

Be sure to replace all screws, and don't forget to put the ROM back on!

  • There are two screws that hold the Main Board to the Display Module
  • There are two screws for the ROM
  • Remember to recconect all those Ribbon Cables! Push the clips back in so that the Cable will not pull out when you gently tug on it!
Also, make sure that you did not lose the serial port protector (is another name for it?) plastic tab thingy from the bottom of the device!
Be sure to not pinch any wires when you reattach the Plastic Shell together at the plastic clips on the side. The picture below should help! The first time I did this, i pinched the wire from the backup battery in the stylus area. I had to push real hard to get my stylus back in place!

When you put the four screws, remember to reattach the main battery compartment's black plastic battery tab (do you like my names for these things? :) )

 

Finally, all back in place! Just replace the batteries, and you will be ready to test your device!